Circutor CMBUS series User Manual download pdf (Page 18)

5�2�4� CMBUS START-UP

Once the slave units and their corresponding M-BUS memory maps have been determined,

and the Modbus parameters to which the converter must respond have been congured, click

the button “Download cong” to send the conguration to the transducer (Figure 17).

Figure 17:Sending the conguration to the CMBUS

Once the conguration has been sent to the unit, the program will display the corresponding

information in the status bar (Figure 18).

Figure 18: Sending of the conguration to CMBUS completed.

To verify the correct reception of the data obtained from the M-BUS slave units, click the TEST

button ( Figure 19). The values reported by the slave units will be shown in the table of Modbus

variables.

Figure 19: Verifying correct data reception with the TEST button

CMBUS

Instruction Manual

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Circutor CMBUS series User Manual Page 18